- #Download flash on mac install
- #Download flash on mac drivers
- #Download flash on mac driver
Insert the USB flash drive if it is not inserted, reboot, and select the EFI volume from the startup selector. Run the following command and enter the admin password when prompted:
Disable SIP by booting to the recovery partition. This has been observed on the late-2014 Mac Mini but may affect other models as well. If Windows does not boot from the USB flash drive after showing the Windows logo, you may have to run the following command to tell the firmware to boot the Windows installer from the USB flash drive. Select EFI volume in the startup selector. Insert the USB flash drive into an available USB port on the Mac. To inject the drivers, the Mac must be booted from the USB flash drive. #Download flash on mac drivers
The $WinPEDriver$ folder is important because it contains the drivers for Windows to boot successfully from the USB flash drive and the hardware on that Mac. Once the flash drive has been created, it should look like this: On the USB flash drive, open the $WinPEDriver$ and remove the IntelMEI folder.
#Download flash on mac install
To install Windows, make sure that the drivers are valid, and restart the installation” message.
#Download flash on mac driver
The 2018 MacBook Air (and potentially Macs after that) cannot load the IntelMEI driver and give a “Windows Setup could not install one or more boot-critical drivers. AutoUnattend.xml provides the location of the $WinPEDriver$ folder to load the drivers during boot. If there is not an AutoUnattend.xml at the top level of the drive (as shown below), download AutoUnattend.xml, unzip it, and add it to the drive. Drag the contents of the Windows Support Software to the USB flash drive. Drag all the files and folders from the mounted ISO to the USB flash drive. To mount the ISO, double-click on the ISO in Finder. Mount the Windows ISO downloaded from Microsoft. To create the USB Flash drive, follow these steps: It does not matter what edition of Windows is used, since Windows is not going to be installed. Select the version of Windows that is closest to the version of Windows installed on the Mac (Windows 8, Windows 10). Windows will not be installed, but the install media will give access to the command line tools in Windows. Windows Install Mediaĭownload the current install media from the Microsoft website. Do not save directly to the USB Flash Drive. Save the Windows Support Software to your desktop or other location. Open Boot Camp Assistant in the Utilities folder and download the current Windows Support Software from the “Action” dropdown in the menu bar. Quit Disk Utility after this operation completes. In Disk Utility, format the Flash drive as exFAT. Insert an 8GB or larger flash drive into a USB port on the Mac. 
The USB Flash drive must be formatted as exFAT. It is important to use this Mac since it will be used to identify the correct Windows drivers.
Windows 10 Installer ISO for Windows 10Īll the preparation is done in macOS on the Mac that is having an issue booting Windows. USB Flash drive (8 GB or larger recommended). It is relatively straightforward to create a bootable USB Flash drive to boot to the Windows 10 installer and open up a DOS prompt for troubleshooting. To troubleshoot an issue with Windows 10 (especially boot-related issues), it can be handy to boot into Windows 10 not installed on a Boot Camp partition.
0 kommentar(er)
